Supply Air
The supply air is led from the ventilation unit through a silencer and via a riser mains (hose) to the distributor units.
A distributor unit is installed for each floor. The distributor is assembled modularly in a simple manner from the "main distributor" and "sub-distributor" elements. Straight distributor modules are usually used instead of standard distributor modules (with elbow) if the distributor is positioned on the storey under the supply air rooms to be connected. The fresh air is led from the sub-distributor through our PluggFlex duct to the air outlet, where it flows into the room. The air volumes for the individual outlets can be set centrally on the distributor by a throttle flap, the total supply air flow rate for the entire house is set on the ventilation unit using a wireless remote control.
A separate PluggFlex duct is used to connect each air outlet. The PK100 PluggFlex duct, for example, is only 50 mm high and is usually installed under the screed on the bare ceiling. For sound insulation reasons, each air outlet is connected with a PK100 duct which is at least 5 m long. This allows Pluggit ventilation systems to completely do without the usual installation of transmitted sound silencers.
Supply air outlets
The air is supplied through an air outlet in the floor or in the wall (under or behind a radiator if possible) which is covered with a grille. Various grilles are available and most of them can be walked on.
You can select the appropriate design for our elegant air outlets from pictures.
